NOX Tiltrotator for Excavator | Technologies

UPPER BRACKET & LOWER QUICK COUPLER
The Tiltrotator can be mounted directly to the excavator arm (direct mount) or it can be »Sandwich« mounted to the excavator by a quick coupler. Preferably, the excavator coupler is the same as the lower quick coupler on the NOX Tiltrotator, but it is not necessarily required. The Tiltrotator can thus be uncoupled and coupled again in no time. The lower quick coupler allows for a safe and fast exchange between attachments.

COMPACT DESIGN
The cylinderless, extremly low and narrow built drive unit allows for very narrow bucket width, that are usually not wider than the excavator boom. Therefore, digging down in deep trenches becomes possible and very easy.

SELFCONTAINED UNIT
The compact design with its fully integrated tilt and rotation unit provides highest safety against damage. There are no protruding cylinders or piston rods that can be damaged, increasing the reliability of the NOX. In addition, the low design maintains higher breakout forces of the machine.

SAFE WORKING AREA
The increased working radius reduces the need for repositioning your excavator to a minimum. Manual works such as manual digging in the danger zone by a co-worker are not necessary, as these works can be managed from the excavator cabin with the NOX Tiltrotator. The S-Lock quick coupler with front-lock prevents the attachments from falling down unintendedly.

PERFECTLY FITTING CONTROL
Always the right control system depending on the machine‘s hydraulic configuration.

A tiltrotator with cylinders only provides a limited tilt angle and has no constant tilt torque.

360° continuous rotation and up to 2 x 50° tilt angle turn your machine into a multifunctional allrounder, increasing the flexibility and efficiency of all your attachments.